Turn signal lever
The turn signal lever can be used to show the following intentions of the driver:
1. Right turn
2. Left turn
3. Lane change to the right (push and hold the lever part- way)
The right hand signals will flash until you release the lever.
4. Lane change to the left (push and hold the lever partway)
The left hand signals will flash until you release the lever.
Turn signals can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
See also:
Repeat play
- Repeating a track
Press the 2 (RPT) button.
To cancel, press the 2 (RPT) button again.
- Repeating all of the tracks on a CD
Press and hold the 2 (RPT) button until you hear a beep.
...
Seat heaters and ventilators
The seat heaters and ventilators heat the seats and maintain good airflow
by blowing air from the seats.
- Front seat heaters/ventilators
1. Turns the seat heater on
The indicator light c ...
Setting speed dials
Select “Set Speed Dial (Speed Dial)”
using a voice command or the “TUNE/SEL” knob.
Pattern A
Select the data to be registered
as a speed dial by either of the following methods, and se ...