Selecting a CD
- Selecting a CD to play
To select the desired CD, press “
”
or “
” on the “TYPE•DISC” button.
- Scanning loaded CDs
Press and hold the “SCAN” button
until you hear a beep.
The first ten seconds of the first track on each CD will be played.
To cancel, press the “SCAN” button again.
Press the button again when the
desired CD is reached.
Playing and pausing tracks
To play or pause a track, press the 3 (
) button.
See also:
Setting speed dials
Select “Set Speed Dial (Speed Dial)”
using a voice command or the “TUNE/SEL” knob.
Pattern A
Select the data to be registered
as a speed dial by either of the following methods, and se ...
Range covered by each camera
1. Front monitor
2. Side-front simultaneous display monitor
3. Side-rear simultaneous display monitor
4. Rear monitor
The illustration shown here is an example. As such, the actual visible area ...
If your vehicle overheats
If the engine overheats:
Stop the vehicle in a safe place
and turn off the automatic air conditioning system.
Check to see if steam is coming
out from under the hood.
If you see steam:
Stop ...
