Deleting the registered data

command or the “TUNE/ SEL” knob. Select “Delete Entry” using a voice command or the “TUNE/ SEL” knob.

Pattern A

either of the following methods, and select “Confirm” using a voice command or the Select the data to be deleted by either of the following methods, and select “Confirm” using a voice command or the “TUNE/SEL” knob:

a. Press the talk switch, and say the name of the desired phone number.

b. Press the talk switch, say “List Names”. When the name of the desired phone number is read aloud, press the talk switch.

Pattern B

using the “TUNE/SEL” knob. Select the desired data to be deleted using the “TUNE/SEL” knob.

    See also:

    Locking the driver’s door from the outside without a key
    Move the inside lock button to the lock position. Close the door. The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode, or the electronic key is ...

    Have the malfunction repaired immediately.
    After taking the specified steps to correct the suspected problem, check that the warning message and light go off. ...

    California Emission Control Warranty
    Vehicles equipped with a California Certified Emission Control System that are registered and operated in California or any state that adopts California emission warranty provisions are covered by ...