Details
You can do the detail settings.
1. Push the “SETUP” button.
2. Touch “Phone”.
3. Touch “Details”.
4. Do each setting according to the following procedures.
5. When you complete each setting, touch “Save”.
Incoming call display
You can select the method of the incoming call display.
1. Touch “Incoming Call Display Mode”.
2. Touch “Full Screen” or “Drop Down”.
“Full Screen” mode
When a call is received, the Hands−free screen is displayed and you can operate it on the screen.
“Drop Down” mode
The message is displayed on the upper side of the screen.
You can only operate the steering switch.
The Bluetooth connection status at start up
When the “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode and the Bluetooth is automatically connected, the connection check is displayed.
When “Display Phone Status” is “On”, this status is displayed.
When “Display Phone Status” is “Off”, this status is not displayed.
1. Touch “Display Phone Status”.
2. Touch “On” or “Off”.
Initializing the settings
You can initialize the settings.
1. Touch “Default”.
2. Touch “Yes”.
See also:
Console box
Console box (if equipped)
Your vehicle is equipped with either a console box or cool box.
For vehicles with the cool box, refer to page 691.
Lift the lid while pulling up the
lower lever to re ...
Registering preset destinations
1 Press the “DEST” button.
2 Touch one of the preset destination
buttons.
A preset destination can be set to any preset
destination button that has not yet
been set.
3 Touch “Yes”.
...
Pre-collision seat belts (front seats of vehicles with pre-collision system)
If the pre-collision sensor detects that a collision is unavoidable, the pre-
collision system will retract the seat belt, thus enhancing the effectiveness of
the seat belt pretensioner in a crash ...