Crawl Control (with Turn Assist function)
Crawl Control allows travel on extremely rough off-road surfaces at a fixed low speed without pressing the accelerator or brake pedal.
To select a speed mode, shift the Crawl Control switch forward or backward.
1 ON/OFF
2 Speed selection switch
3 Multi-information display
The operating status and speed select status
of the Crawl Control are shown on the
multi-information display.
4 Indicator
The Crawl Control indicator is lit and the
slip indicator flashes when operating.
■Speed modes
The following table shows some typical terrains and the recommended speed modes.
■Turn Assist function
This function assists cornering performance in accordance with steering operation when driving through a tight corner. It maintains vehicle speed while driving and reduces the number of turns needed to navigate a corner that requires turning the wheel in the opposite direction.
Press the Turn Assist switch while Crawl Control is operating.
Turn Assist indicator will come on.
To turn the system off, press the switch again.
See also:
Cleaning and protecting the vehicle exterior
Perform the following to protect the vehicle and maintain it in prime condition:
• Working from top to bottom, liberally apply water to the vehicle body, wheel
wells and underside of the vehicle ...
Antenna locatioand effective range
Antenna location
1 Antennas outside cabin
2 Antennas inside cabin
3 Antenna outside luggage
compartment
Effective range (areas withiwhich the electronic key is
detected)
•Whelocking or un ...
Some basics
This section describes some of the basic features of your audio/video system.
Some information may not pertain to your system.
Your audio/video system works when the “ENGINE START STOP” switch i ...