Inside rear view mirror
In automatic mode, sensors are used to detect the headlights of vehicles behind and the reflected light is automatically reduced.
Without compass
1. Turns automatic mode on
2. Turns automatic mode off
The indicator comes on when automatic mode is turned on.
The mirror reverts to automatic mode each time the “ENGINE START STOP” switch is turned to IGNITION ON mode.
With compass
Turns automatic mode on/off
The indicator comes on when automatic mode is turned on.
The mirror reverts to automatic mode each time the “ENGINE START STOP” switch is turned to IGNITION ON mode.
Adjusting the height of rear view mirror
Adjust the height of the rear view mirror by moving it up and down.
To prevent sensor error
To ensure that the sensors operate properly, do not touch or cover them.
CAUTION
Caution while driving
Do not adjust the position of the mirror while driving.
Doing so may lead to mishandling of the vehicle and may cause an accident, result- ing in death or serious injury.
See also:
Seat belts
Make sure that all occupants are wearing their seat belts before driving the
vehicle.
- Correct use of the seat belts
1. Extend the shoulder belt so that it comes fully over the shoulder, ...
Address book
Navigation settings
Points or areas on the map can be registered.
The registered points can be used on the
“Destination” screen.
Registered areas to avoid, will be avoided
when the system ...
Have the vehicle inspected by your Lexus dealer immediately.
A buzzer sounds and a warning message is shown on the multi-informa- tion display.
Failure to investigate the cause of the following warnings may lead to the system
operating abnormally and possib ...