Power windows
The power windows can be opened and closed using the switches.
Operating the switch moves the windows as follows:
1. Closing
2. One-touch closing*
3.Opening
4. One-touch opening*
*:Pushing the switch in the opposite direction will stop window travel partway.
Window lock switch
Press the switch down to lock the passenger window switches.
The indicator will come on.
Use this switch to prevent children from accidentally opening or closing a passenger window.
The passenger windows can still be opened and closed using the power window switches on the driver’s side even if the lock switch is on.
The power windows can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
Operating the power windows after turning the engine off
The power windows can be operated for approximately 45 seconds even after the “ENGINE START STOP” switch is turned to ACCESSORY mode or turned off.
They cannot, however, be operated once either front door is opened.
Jam protection function
If an object becomes caught between the window and the window frame, window travel is stopped and the window is opened slightly.
When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot be closed, perform the following operations using the power window switch on the relevant door.
• After stopping the vehicle, the window can be closed by holding the power window switch in the one-touch closing position while the “ENGINE START STOP” switch is turned to IGNITION ON mode.
• If the window still cannot be closed even by carrying out the operation explained above, initialize the function by performing the following procedure.
Hold the power window switch in the one-touch closing position. Continue holding the switch for a further 6 seconds after the window has closed.
Hold the power window switch in the one-touch opening position. Continue holding the switch for a further 2 seconds after the window has opened completely.
Hold the power window switch in the one-touch closing position once again. Continue holding the switch for a further 2 seconds after the window has closed.
If you release the switch while the window is moving, start again from the beginning.
If the window continues to close but then re-open slightly even after performing the above procedure correctly, have the vehicle inspected by your Lexus dealer.
Door lock linked window operation
The power windows can be opened and closed using the mechanical key.
The power windows can be opened using the wireless remote control.
Customization
Settings (e.g. linked door lock operation) can be changed.
CAUTION
Closing the windows
Observe the following precautions.
Failing to do so may result in death or serious injury.
• Check to make sure that all passengers do not have any part of their body in a position where it could be caught when a window is being operated.
• Do not allow children to operate the power windows.
Closing a power window on someone can cause serious injury, and in some instances, even death.
Jam protection function
• Never use any part of your body to intentionally activate the jam protection function.
• The jam protection function may not work if something gets caught just before the window fully closes.
See also:
Is the Dispute Settlement Program subject to change?
The information in this booklet about the program is correct as of the date of
printing. However, the program may be changed without notice.
Contact the Lexus Customer Satisfaction Department at (8 ...
Setting or changing the PIN
- Setting a PIN
Select “Set PIN” using a voice command
or the “TUNE/SEL” knob.
Enter a PIN using a voice command
or the “TUNE/SEL” knob.
When using the “TUNE/SEL” knob, ...
Safety Connect LED light Indicators
When the “ENGINE START STOP” switch is turned to IGNITION ON mode, the red indicator
light comes on for 2 seconds then turns off.
Afterward, the green indicator light comes on, indicating that ...